TP-Link TL-SL5428 - Figure 3-65 MAC Authentication Port Configuration

AAA Authorization and Accounting
3-99
3
• Status – Indicates whether MAC Authentication is enabled or disabled for the port.
See “Configuring MAC Authentication for Ports” on page 3-94. The following
parameters are unavailable for modification if MAC Authentication is not enabled
for the port.
• Max MAC Count – The maximum allowed amount of MAC authenticated MAC
addresses on the port. (Default: 1024; Range: 1-1024)
• Intrusion Action – The switch can respond in two ways to an intrusion.
- Block Traffic – All traffic for the unauthenticated host is blocked.
- Pass Traffic – All traffic for the unauthenticated host is allowed.
• Trunk – Indicates if the port is a trunk member.
Web – Click Security, MAC Authentication. Modify the Maximum MAC Count and
Intrusion Action. Click Apply.
Figure 3-65 MAC Authentication Port Configuration
CLI – This example configures the maximum MAC count to 32 and sets the intrusion
action to block all traffic for port 1.
Console(config)#interface ethernet 1/1 4-166
Console(config-if)#mac-authentication max-mac-count 24 4-122
Console(config-if)#mac-authentication intrusion-action block-traffic4-122
Console(config-if)#