Command Line Interface
4-296
4
Command Usage
Multicast router port types displayed include Static.
Example
The following shows that port 11 in VLAN 1 is attached to a multicast router:
IGMP Filtering and Throttling Commands
In certain switch applications, the administrator may want to control the multicast
services that are available to end users. For example, an IP/TV service based on a
specific subscription plan. The IGMP filtering feature fulfills this requirement by
restricting access to specified multicast services on a switch port, and IGMP
throttling limits the number of simultaneous multicast groups a port can join.
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Ports Type
---- ------------------- -------
1 Eth 1/11 Static
2 Eth 1/12 Static
Console#
Table 4-32 IGMP Filtering and Throttling Commands
Command Function Mode Page
ip igmp filter Enables IGMP filtering and throttling on the switch GC 4-298
ip igmp profile Sets a profile number and enters IGMP filter profile
configuration mode
GC 4-298
permit, deny Sets a profile access mode to permit or deny IPC 4-299
range Specifies one or a range of multicast addresses for a
profile
IPC 4-299
ip igmp filter Assigns an IGMP filter profile to an interface IC 4-300
ip igmp max-groups Specifies an IGMP throttling number for an interface IC 4-300
ip igmp max-groups action Sets the IGMP throttling action for an interface IC 4-301
show ip igmp filter Displays the IGMP filtering status PE 4-302
show ip igmp profile Displays IGMP profiles and settings PE 4-302
show ip igmp throttle interface Displays the IGMP throttling setting for interfaces PE 4-303
To Next Page
Loading...
