TP-Link TL-SL5428 - Configuring VLAN Interfaces; Interface Vlan

VLAN Commands
4-243
4
Example
The following example adds a VLAN, using VLAN ID 105 and name RD5. The VLAN
is activated by default.
Related Commands
show vlan (4-250)
Configuring VLAN Interfaces
interface vlan
This command enters interface configuration mode for VLANs, which is used to
configure VLAN parameters for a physical interface.
Syntax
interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4092, no leading zeroes)
Default Setting
None
Command Mode
Global Configuration
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#
Table 4-16 Configuring VLAN Interfaces
Command Function Mode Page
interface vlan Enters interface configuration mode for a specified VLAN GC 4-244
switchport mode Configures VLAN membership mode for an interface IC 4-245
switchport
acceptable-frame-types
Configures frame types to be accepted by an interface IC 4-246
switchport ingress-filtering Enables ingress filtering on an interface IC 4-246
switchport native vlan Configures the PVID (native VLAN) of an interface IC 4-247
switchport allowed vlan Configures the VLANs associated with an interface IC 4-248
switchport gvrp Enables GVRP for an interface IC 4-240
switchport forbidden vlan Configures forbidden VLANs for an interface IC 4-249
switchport priority default Sets a port priority for incoming untagged frames IC 4-265