Configuring the Switch
3-136
3
Changing the Aging Time
You can set the aging time for entries in the dynamic address table.
Command Attributes
• Aging Status – Enables/disables the function.
• Aging Time – The time after which a learned entry is discarded.
(Range: 10-630 seconds; Default: 300 seconds)
Web – Click Address Table, Address Aging. Specify the new aging time, click Apply.
Figure 3-86 Setting the Address Aging Time
CLI – This example sets the aging time to 300 seconds.
Console(config)#mac-address-table aging-time 300 4-192
Console(config)#
To Next Page
Loading...
