Configuring the Switch
3-8
3
GVRP Status Enables GVRP on the switch 3-160
802.1Q Tunnel
Configuration
Enables 802.1Q (QinQ) Tunneling 3-172
Basic Information Displays information on the VLAN type supported by this switch 3-161
Current Table Shows the current port members of each VLAN and whether or
not the port is tagged or untagged
3-161
Static List Used to create or remove VLAN groups 3-163
Static Table Modifies the settings for an existing VLAN 3-164
Static Membership by Port Configures membership type for interfaces, including tagged,
untagged or forbidden
3-166
Port Configuration Specifies default PVID and VLAN attributes 3-167
Trunk Configuration Specifies default trunk VID and VLAN attributes 3-167
Tunnel Port Configuration Adds an interface to a QinQ Tunnel 3-174
Tunnel Trunk Configuration Adds an interface to a QinQ Tunnel 3-174
Private VLAN 3-175
Information Displays Private VLAN feature information 3-176
Configuration This page is used to create/remove primary or community
VLANs
3-177
Association Each community VLAN must be associated with a primary VLAN 3-178
Port Information Shows VLAN port type, and associated primary or secondary
VLANs
3-179
Port Configuration Sets the private VLAN interface type, and associates the
interfaces with a private VLAN
3-180
Trunk Information Shows VLAN port type, and associated primary or secondary
VLANs
3-179
Trunk Configuration Sets the private VLAN interface type, and associates the
interfaces with a private VLAN
3-180
Protocol VLAN 3-181
Configuration Configures protocol VLANs 3-181
System Configuration Configures protocol VLAN system parameters 3-182
LLDP 3-183
Configuration Configures global LLDP timing parameters 3-183
Port Configuration Configures parameters for individual ports 3-185
Trunk Configuration Configures parameters for trunks 3-185
Local Information Displays LLDP information about the local device 3-188
Table 3-2 Main Menu (Continued)
Menu Description Page
To Next Page
Loading...
