Contents
iv
Setting Static Addresses 3-134
Displaying the Address Table 3-135
Changing the Aging Time 3-137
Spanning Tree Algorithm Configuration 3-137
Configuring Port and Trunk Loopback Detection 3-139
Displaying Global Settings 3-141
Configuring Global Settings 3-143
Displaying Interface Settings 3-147
Configuring Interface Settings 3-149
Configuring Multiple Spanning Trees 3-151
Displaying Interface Settings for MSTP 3-154
Configuring Interface Settings for MSTP 3-156
VLAN Configuration 3-158
IEEE 802.1Q VLANs 3-158
Enabling or Disabling GVRP (Global Setting) 3-161
Displaying Basic VLAN Information 3-162
Displaying Current VLANs 3-162
Creating VLANs 3-164
Adding Static Members to VLANs (VLAN Index) 3-165
Adding Static Members to VLANs (Port Index) 3-167
Configuring VLAN Behavior for Interfaces 3-168
Configuring IEEE 802.1Q Tunneling 3-170
Enabling QinQ Tunneling on the Switch 3-173
Adding an Interface to a QinQ Tunnel 3-175
Private VLANs 3-176
Displaying Current Private VLANs 3-177
Configuring Private VLANs 3-178
Associating VLANs 3-179
Displaying Private VLAN Interface Information 3-180
Configuring Private VLAN Interfaces 3-181
Protocol VLANs 3-182
Protocol VLAN Group Configuration 3-182
Protocol VLAN System Configuration 3-183
Link Layer Discovery Protocol 3-184
Setting LLDP Timing Attributes 3-184
Configuring LLDP Interface Attributes 3-186
Displaying LLDP Local Device Information 3-189
Displaying LLDP Remote Port Information 3-190
Displaying LLDP Remote Information Details 3-191
Displaying Device Statistics 3-192
Displaying Detailed Device Statistics 3-193
Class of Service Configuration 3-194
Layer 2 Queue Settings 3-194
Setting the Default Priority for Interfaces 3-194
Mapping CoS Values to Egress Queues 3-195
To Next Page
Loading...
