Tracker Off-Road EViS 2020 - ACCELERATOR; ACCELERATOR PEDAL

B
ACCELERATOR
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
11
Repair and Service Manual
10002660
ACCELERATOR
Fig. 1 Accelerator Components
ACCELERATOR PEDAL
The accelerator is a throttle by wire system with a rotary
position sensor (See Rotary Position Sensor on page 47).
There are no serviceable items within the accelerator
pedal assembly. The pedal assembly must be replaced
as a unit if it does not operate correctly.
Pedal Replacement
Tool List Qty.
Socket, 7/16” ............................................................... 1
Socket, 13 mm
Wrench, 7/16”.............................................................. 1
Wrench, 13 mm
Ratchet........................................................................ 1
Torque Wrench, ft.lbs .................................................. 1
1. To access the accelerator pedal (1), remove two
bolts (3), washers (4) and nuts (7) that secure the
cover (5) to the mounting bracket (10).
2. Disconnect the wire harness from the rotary position
sensor on the pedal.
3. Remove the lock nuts (8) securing the pedal (1) to
the mounting bracket.(10).
4. Remove the pedal.
5. Replace the pedal (1) and secure with new lock nuts
(8).
6. Connect the wiring harness to the rotary position
sensor.
7. Install the pedal cover (5) and secure it with the bolts
(3), washers (4) and nuts (7).
8. Tighten the nuts (7, 8) to the torque values specified
below.
Rotary Position
Sensor
1
3
4
5
7
10
8
Item Torque Specification
7
6 - 8 ft. lbs. (8 - 11 Nm)
8
6 - 8 ft. lbs. (8 - 11 Nm)