TracVision TV3 User’s Guide
18
Network Settings
Once the TV-Hub is connected to your onboard network, you can
access its web interface by entering the TV-Hub’s dynamically
assigned IP address in the web browser of any device connected to the
network. You can find the TV-Hub’s IP address on the web interface
(select Settings > Network Settings).
If Bonjour is installed on your device, you can use it to find the
TV-Hub on the onboard network without knowing the IP address. Just
search for its host name: TVHub-<TV-Hub serial number>. For more
information about Bonjour, visit www.apple.com/support/bonjour.
NOTE: In Dynamic (DHCP) mode, the TV-Hub could get assigned a
different IP address whenever it is turned on. If you prefer, you can assign a
static IP address to the TV-Hub that never changes, even after a reboot. See
“TV-Hub Ethernet Settings” on page 19 for details.
Connecting the TV-Hub to Your Onboard Network Using its Built-in
Wi-Fi
Although not recommended, you can modify the TV-Hub’s wireless
settings to connect to your onboard network using its Wi-Fi antenna,
rather than using an Ethernet cable. However, once you change the
TV-Hub’s wireless settings from Access Point mode to Infrastructure
mode, you will lose the ability to connect directly to the TV-Hub using
your mobile device – you will always have to connect via the network.
See “TV-Hub Wireless Settings” on page 21 for details.
To Next Page
Loading...