TracVision TV3 User’s Guide
32
Antenna Settings
Advanced Settings
The following modes are special features that enhance the
performance of the TracVision antenna. You can enable/disable these
modes at the web interface (go to Settings > Advanced Settings).
• Sleep Mode: When you are moving, the antenna’s motors
need to run continuously to keep the antenna pointed at
the satellite and locked onto the peak signal. However, if
you are stationary, the motors don’t need to run since the
antenna’s orientation to the satellite doesn’t change. In
these stationary conditions, Sleep mode locks the antenna
in place and shuts down the motors to conserve power and
silence the antenna. KVH recommends that you keep Sleep
mode set to ON (default setting).
• Sidelobe Mode: This mode only applies to the TracVision
TV6 model.
To Next Page
Loading...