TracVision TV3 User’s Guide
31
Antenna Settings
To configure the system to use data from a connected NMEA device,
follow these steps:
1. Configure your NMEA device to transmit one or more of the
following NMEA 0183 messages at 4800 baud:
2. Select the NMEA source at the TracVision Setup Wizard. You
can launch the Setup Wizard from the web interface (go to
Settings > General Settings).
$--xxx Message Description
HDG Heading, Deviation and Variation
HDM Heading, Magnetic
HDT Heading, True
OSD Own Ship Data
THS True Heading and Status
VHW Water Speed and Heading
RMC GNSS Position Data
To Next Page
Loading...