CVHE-SVX005C-EN
93
NOTICE
Equipment Damage!
Failure to follow instructions could result in
equipment damage.
Do NOT use Teflon-based tape or paste on anode; a
small amount of liquid sealant (Loctite® 242 or
equivalent) may be applied to prevent leakage when
installing an anode, but do not apply so much sealant
that it prevents the necessary electrical connection
between the anode and the waterbox.
As needed after draining the waterbox, use a 2-1/2 in.
(63.5 mm) wrench to remove/install Trane-supplied
waterbox anodes.
Recommended Maintenance
To Next Page
Loading...
