TRENDnet PoE Web Smart Switch Series User Manual

© Copyright 2018 TRENDnet. All Rights Reserved.
91
TRENDnet User’s Guide
PoE Web Smart Switch Series
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Interfaces
Security > DHCP Snooping > Interfaces
This section allows you to set trusted port interfaces where DHCP servers can be
connected allows or denies DHCP server information to be received on those ports.
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on Security, click on DHCP Snooping, and click on Interfaces.
3. Next to each port, click the Trust drop-down list and select one of the following
options.
 Disable: This parameter defines the port as untrusted for the DHCP Snooping
feature.
 Enable: This parameter defines the port as trusted for the DHCP Snooping
feature.
Note: You can select the row labeled ALL to apply settings to all ports.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.

TRENDnet PoE Web Smart Switch Series Specifications

General

Brand	TRENDnet
Model	PoE Web Smart Switch Series
Category	Switch
Language	English