TRENDnet PoE Web Smart Switch Series - ARP Inspection Port Settings; ARP Inspection VLAN

© Copyright 2018 TRENDnet. All Rights Reserved.
94
TRENDnet User’s Guide
PoE Web Smart Switch Series
ARP Inspection Port Settings
Security > Dynamic ARP Inspection > ARP Inspection Port Settings
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on Security, click on Dynamic ARP Inspection, and click on ARP Inspection Port
Settings.
3. Select the Port then its Trust State. Click apply to save.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
ARP Inspection VLAN
Security > Dynamic ARP Inspection > ARP Inspection VLAN
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on Security, click on Dynamic ARP Inspection, and click on ARP Inspection VLAN
3. Select the VID List then its State. Click apply to save.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.