TRENDnet PoE Web Smart Switch Series User Manual

© Copyright 2018 TRENDnet. All Rights Reserved.
54
TRENDnet User’s Guide
PoE Web Smart Switch Series
MLD Snooping
Settings
Network > MLD Snooping > Settings
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on Network, click on MLD Snooping, and click on Settings.
3. Review the settings. Click Apply to save the settings.
 MLD Snooping Status – Click the drop-down list and select Enabled to enable
MLD snooping.
 Aging Timeout – Enter the aging timeout in seconds.
 Querier Status – Click the drop-down list and select Enabled to enable the
Querier Election or Disabled to disable this feature.
 Fast Leave Status – Click the drop-down list and select Enabled to enable fast
leave or Disabled to disable this feature.
 Query Interval – Enter the amount of time you want your switch to send
queries.
 Max Response Time – Enter the maximum response time in seconds that client
can wait before responding to a query.
 Robustness Variable – Enter the robustness value used to determine the
number of times to send a message.
 Last Member Query Interval – Enter the interval between the last member
queries.
 Router Timeout – Enter the amount of time before the router times out.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.

TRENDnet PoE Web Smart Switch Series Specifications

General

Brand	TRENDnet
Model	PoE Web Smart Switch Series
Category	Switch
Language	English