© Copyright 2018 TRENDnet. All Rights Reserved.
PoE Web Smart Switch Series
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Configure IPv6 Routing Table
System > L3 Feature > IPv6 Static/Default Route
This section allows you to set your switch’s IPv6 routing table default, or specify a static
route.
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on System, L3 Feature, and then IPv6 Static/Default Route.
3. Review the settings. When you have completed making changes, click Apply to save
the settings, click Delete to delete the routing table entry.
Default Route: Check this box to apply this route as the default, uncheck the box
to specify the following:
o IPv6 Address/Prefix length: Enter the IP address for this routing entry.
Interface VLAN: Specify the VLAN ID to apply this route to.
Next Hop IPv6 Address: Enter the next hop for the routing entry.
Backup Status: Specify if this routing entry is to be the Primary or Backup entry.
To Next Page
Loading...
Need help?
General