© Copyright 2018 TRENDnet. All Rights Reserved.
PoE Web Smart Switch Series
ARP Inspection Statistics
Security > Dynamic ARP Inspection > ARP Inspection Statistics
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on Security, click on Dynamic ARP Inspection, and click on ARP Inspection
Statistics
3. Select the VID List then click Clear.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
ARP Inspection VLAN
Security > Dynamic ARP Inspection > ARP Inspection VLAN
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on Security, click on Dynamic ARP Inspection, and click on ARP Inspection VLAN
3. Select the Log Buffer then Apply to view.
To Next Page
Loading...
