© Copyright 2018 TRENDnet. All Rights Reserved.
PoE Web Smart Switch Series
o SNTP – Allows you to configure your switch to pull time and date
settings automatically from a network time server. If selecting this
option, under Simple Network Time Protocol (SNTP) Settings, enter
your time server settings.
Note: Please note that in order for the switch to communicate to
Internet SNTP time servers, the switch must have valid IPv4/IPv6
address settings including a default gateway address for Internet
access. Additionally, if using a domain name, the switch must be
configured with valid DNS server settings in order to resolve
host/domain names.
SNTP Primary Server – Enter the primary network time server
IPv4 address, IPv6 address, or Domain Name.
SNTP Secondary Server – Enter the secondary network time
server IPv4 address, IPv6 address, or Domain Name.
SNTP Poll Interval – Enter the interval time when your switch
will update the time and date settings with the time server.
Time Zone – Click the drop-down list to select your time zone.
Additionally, you can set your Daylight Savings Time.
Additional Time Parameters – Allows you to configure additional Daylight
Saving Time parameters.
Daylight Savings Time Status: Click the drop-down list to
enable or disable Daylight Savings.
From: Set the daylight savings start date and time.
To: Set the daylight savings end date and time.
DST Offset: Click the drop-down list to set the time offset
based on respective time zone.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
To Next Page
Loading...
Need help?
General