© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-718BRM
17
3. To add a wireless device to your network, simply the push the WPS button on the
wireless device (consult wireless device’s User’s Guide for length of time), you are
connecting, then in your router management page, make sure the Config Method is set
to Push Button (default setting) and click on the Trigger button at the bottom of the
page.
4. The WPS Status area will display status messages about the WPS process.
5. The WPS Status area will display “Configured” message to indicate that the wireless
client device successfully connected using WPS.
PIN (Personal Identification Number)
Setup > Wireless Settings > WPS Setup
If your wireless device has WPS PIN (typically an 8-digit code printed on the wireless
device product label or located in the wireless device wireless software utility), you can
use this method.
1. Log into your router management page (see “Access your router management page”
on page 35
).
2. Click on Setup and click Wireless Settings, then click on the WPS Setup button at the
bottom of the page.
3. Next to Config Status, click Release. The status will change to Unconfigured.
4. Click the Config Method drop-down list and select PIN Code. Click Apply.
5. In the empty field, enter the 8-digit WPS PIN of the wireless client device you are
connecting and click Trigger.
Note: You may need to initiate the WPS PIN on your wireless device first when using this
method. Refer to your wireless device documentation for details on the operation of
WPS.
6. The WPS Status area will display “Configured” message to indicate that the wireless
client device successfully connected using WPS.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
