© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-718BRM
45
3. Review the virtual server settings.
• Service Ports – Enter the port number required by your device. This will be the
same port number used to access the device from the Internet and will include
both TCP and UDP protocols.
Note: Please refer to the device documentation to determine which ports and
protocols are required.
• Server IP – Enter the IP address of the device to forward the port. (e.g.
192.168.10.101).
Note: You should assign a static IP address to the device or use DHCP
reservation to ensure the IP address of the device does not change.
• Enable – Checking the Enable option turns on the virtual server.
• Schedule - Click the drop-down list assign a pre-defined schedule when the
virtual server is activated or inactive.
Note: To define a schedule, see the “Create schedules” section.
4. To save changes, click Apply.
Note: If using ADSL WAN with multiple PVCs, click the Virtual Server Mode drop-down
list to select MultiMode which will allow you which PVC to assign the Virtual Server.
Example: To forward TCP port 80 to your IP camera
1. Make sure to configure your network/IP camera to use a static IP address or you can
use the DHCP reservation feature (see “Set up DHCP reservation” on page 53).
Note: You may need to reference your camera documentation on configuring a static IP
address.
2. Log into your router management page (see “Access your router management page”
on page 35
).
3. Click on Advanced, click on NAT, and click on Virtual Server.
4. In the Well known services drop-down list, select the pre-defined virtual server entry
named WEB (80). In the ID drop-down list, select 1. Click Copy to.
5. ID 1 fields will be populated with the selected pre-defined virtual server entry.
6. Under Server IP, enter the IP address assigned to the camera. (e.g. 192.168.10.101)
7. To save changes, click Apply.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
