TRENDnet TEW-750DAP User Manual

© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-750DAP
2
Security
Encrypted Wireless
Support for wireless encryption of up to WPA2
Multiple SSIDs
Create multiple SSIDs per wireless band
Performance
N600 Wireless
Proven concurrent dual band 300 Mbps Wireless N
Wireless Coverage
Extended wireless coverage with MIMO antenna technology
Compatibility
Compatible with legacy wireless devices
Energy Savings
Embedded GREENnet technology reduces power consumption by up to
50%
IPv6
IPv6 network support
*Maximum wireless signal rates are referenced from IEEE 802.11 theoretical
specifications. Actual data throughput and coverage will vary depending on
interference, network traffic, building materials and other conditions
Product Hardware Features
Rear View
• Reset Button – Press and hold this button for 10 seconds to reset the access
point.
• WPS Button (Wi-Fi Protected Setup) – Push and hold this button for 5 seconds
to activate WPS. The Power LED will blink when WPS is activated.
Note: WPS is only available when the device is in Access Point mode.
• Ethernet LAN Ports 1-4 – Connect Ethernet cables (also called network cables)
from your access point to your router and wired network devices.
• Power Port – Connect the included power adapter from your access point
power port and to an available power outlet.
• On/Off Power Switch – Push the access point On/Off power switch to turn
your access point “On” (Inner position) or “Off” (Outer position).
Reset Button
10/100Mbps
Ethernet LAN
Ports 1-4
Power Port
WPS Button
On/Off Power Switch

TRENDnet TEW-750DAP Specifications

Operating Environment

operating temperature	0 - 40 °C
operating humidity	Max. 95% non-condensing

Power

input voltage	100 - 240 V AC
output voltage	12 V DC
power consumption	10.1 Watts

Antenna and Wireless

antenna gain 2.4 GHz	2 x 1.5 dBi
antenna gain 5 GHz	2 x 4 dBi
wireless output power 802.11a	15 dBm

Weight and Dimensions

weight	238 g
dimensions	45 x 118 x 164 mm