TRENDnet TEW-750DAP User Manual

© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-750DAP
44
Set your access point date and time
Main > Time
1. Log into your access point management page (see “
Access your access point
management page” on page 11).
2. Click on Main, and click on Time.
3. Review the Time settings. Click Save Settings to save settings.
• Time: Displays the current device time and date information.
• Time Zone – Click the drop-down list and select your time zone.
• Enable Daylight Saving: Check the option to enable daylight savings time and set
the annual range when daylight saving is activated.
• Automatically synchronize with Internet Time Server – Check the optionerver
option to set your access point date and time to synchronize with an NTP
(Network Time Protocol) server address (e.g. pool.ntp.org). Enter the NTP server
address next to Default NTP server, (e.g. pool.ntp.org). Click the Time Zone drop-
down list to select the appropriate zone and you can optionally change your NTP
Sync period.
Note: NTP servers are used for computers and other network devices to
synchronize time across an entire network.
• Manually set time – Set your access point date and time manually in the Date
and Time Settings section. Note: Time is specified in 24-hour format. In addition,
you can click Synchronize with Your Computer’s Time Settings to copy the time
and date settings from your computer.

TRENDnet TEW-750DAP Specifications

Operating Environment

operating temperature	0 - 40 °C
operating humidity	Max. 95% non-condensing

Power

input voltage	100 - 240 V AC
output voltage	12 V DC
power consumption	10.1 Watts

Antenna and Wireless

antenna gain 2.4 GHz	2 x 1.5 dBi
antenna gain 5 GHz	2 x 4 dBi
wireless output power 802.11a	15 dBm

Weight and Dimensions

weight	238 g
dimensions	45 x 118 x 164 mm