Trimble R7 User Manual

18 Default Settings
158 Trimble R7/R8 GPS Receiver User Guide
Trimble R8 Operation
18.1 Introduction
All Trimble R8 receiver settings are stored in application files. The
default application file, DEFAULTS is stored permanently in the
receiver, and contains the factory default settings for the receiver.
Whenever the receiver is reset to its factory defaults, the current
settings (stored in the current application file, CURRENT) are reset to
the values in the default application file.
You cannot modify the default application file. However, if there is a
power up application file (POWER_UP) in the receiver, the settings in
this file can be applied immediately after the default application file,
overriding the factory defaults.
For more information about application files, see Application Files,
page 135.

Trimble R7 Specifications

General

Brand	Trimble
Model	R7
Category	GPS
Language	English