Trimble R7 User Manual

9 Default Settings
84 Trimble R7/R8 GPS Receiver User Guide
Trimble R7 Operation
9.1 Introduction
All Trimble R7 receiver settings are stored in application files. The
Default application file, Default.cfg, is stored permanently in the
receiver, and contains the factory default settings for the Trimble R7.
Whenever the receiver is reset to its factory defaults, the current
settings (stored in the Current application file, Current.cfg) are reset to
the values in the Default application file.
You cannot modify the Default application file. However, if there is a
Power Up application file (Power_Up.cfg) in the receiver, the settings
in this file can be applied immediately after the Default application
file, overriding the factory defaults.
For more information about application files, see Application Files,
page 55.

Trimble R7 Specifications

General

Brand	Trimble
Model	R7
Category	GPS
Language	English