Trimble R7 User Manual

3 Setting up the Receiver
20 Trimble R7/R8 GPS Receiver User Guide
Trimble R7 Operation
3.4 Postprocessed Setup
For a postprocessed survey, you only need:
• the Trimble R7 receiver
• a Zephyr™ or Zephyr Geodetic antenna
• a GPS antenna cable
Other equipment, as described below, is optional.
To set up the Trimble R7 for a postprocessed survey:
1. Set up the tripod with the tribrach and antenna adapter over the
survey mark.
Instead of a tripod, you can use a range pole with a bipod.
However, Trimble recommends that you use a tripod for greater
stability.
2. Mount the antenna on the tribrach adapter.
3. Use the tripod clip to hang the receiver on the tripod.
4. Connect the yellow GPS antenna cable to the Zephyr antenna.
5. Connect the other end of the GPS antenna cable to the yellow
TNC port on the receiver.
6. If external power is required, connect a battery with a 0-shell
Lemo connection to Port 2 or Port 3 on the receiver.

Trimble R7 Specifications

General

Brand	Trimble
Model	R7
Category	GPS
Language	English