Trimble R7 User Manual

6 Transferring Data
68 Trimble R7/R8 GPS Receiver User Guide
Trimble R7 Operation
6.1 Deleting Files in the Receiver
You can delete files stored in the receiver at any time. Do one of the
following:
• Use the Data Transfer utility in Trimble Geomatics Office.
• Use the TSC1/TSCe controller.
• Hold down the power button p for 30 seconds after the
receiver has been powered on. (When you use this method, all
data is deleted, and the CompactFlash card is reformatted.)
• Use GPS Configurator.
6.2 Supported File Types
Table 6.1 shows the file types that you can transfer to or from a
Trimble R7 receiver, and the software or utility that you must use to
transfer each file type.
Note – The Trimble R7 receiver supports a maximum of 512 files on
the CompactFlash card. Files stored on the compact flash must be 8.3
format. The Trimble R7 receiver does not support extended file names.
Table 6.1 Supported file types
File Type Extensions Transfer from
Trimble R7?
Transfer to
Trimble R7?
Software
Ephemeris .eph Yes No Data Transfer
Raw observations .T01, .dat Yes No Data Transfer
Receiver firmware files .elf No Yes WinFlash
Application files .cfg Yes Yes GPS
Configurator

Trimble R7 Specifications

General

Brand	Trimble
Model	R7
Category	GPS
Language	English