Open the water heater compartment door.
Find the selector switch and set it to 120-volt
electrical. Refer to the operating instructions
included in the information package.
Motor Aid Water Heater (Commander Only):
Your motorhome is equipped with a system
whereby heat from the engine cooling system
is used to heat water in your fresh water sys-
tem while you are driving. This is referred to
as a “motor aid”. Hoses from the engine cool-
ing system are routed to a heat exchanger sur-
rounding the water heater tank. As a rule, the
water in the heater tank will be heated to about
140 degrees F in about 2 hours or 100 miles of
driving time. This means that you will have hot
water at the faucets when you arrive at your
campsite or any time while you are driving.
The motor aid water heater also provides ad-
ditional cooling capacity to your engine cooling
system allowing the engine to run cooler under
a. The water heater is equipped with a preset
water temperature control. The burner
will bring the water temperature up to the
desired level and then automatically shut
b. It is also equipped with a temperature cut-
off device in case the water temperature
exceeds the preset limit. The breaker will
trip and shut down the burner. Before the
burner will restart, the breaker will have to
be reset. If it continues to trip, have the
unit checked and serviced. Refer to manu-
facturers operating instructions included in
To protect the surface of your ABS plastic shower
pan, it is recommended that a rubber shower mat
be placed in the shower pan.
Use a non-abrasive cleaner to clean your shower
compartment. Do not use highly concentrated or
high acid content household cleaners, as these
may damage the shower compartment.
Refer to manufacturer's operating instructions
included in information package for more details.
Water keeps running into the bowl:
Check to see that the levers return all the way
to the left. Sticking may be caused by foreign
material on the waste valve blade or blade seal
at the bottom of the bowl. If problem persists,
Toilet leaks, there is water on the fl oor:
If the leak is in back of the toilet, check the
water supply line connection and refer to the
installation instructions. If the leak is at the
closet fl ange area, check the closet fl ange
nuts for tightness. If leak continues, remove
the toilet and check the closet fl ange height.
The height should be between 1/4" and 7/16"
above the fl oor. Adjust accordingly and re-
place the closet fl ange seal if damaged.
The levers must be held fully open during the
fl ush. A good fl ush should be obtained within 2
to 3 seconds. If the problem persists, remove
the water supply line and check the water sup-
ply. The water supply line fl ow rate should be
at least 8 liters per minute to ensure an ad-
CAUTION
Should you ever develop a leak in the
engine cooling system, do not forget
to check the motor aid water heater
supply hoses and connections for
leaks in addition to the regular cool-
ing system area.
IMPORTANT
Be sure there is water in the hot water
tank to prevent burning out the heating
element when the power is turned on.
COMMANDER / EMBASSY
To Next Page
Loading...
