Triple E COMMANDER - Signal Amplifier; Dash Television 120 V (Only)

Dash
13-8
COMMANDER / EMBASSY
3.
Rotating the Antenna:
After antenna is in the up position, pull down
the rotating knob until it disengages the ceiling
plate. Rotate the antenna for best sound and
picture.
4.
Lowering the Antenna:
Rotate the antenna until the pointer on the
rotating knob and the ceiling plate align. Turn
the crank in the down (counterclockwise)
direction until some resistance is noticed. The
antenna is now locked in the travel position.
Turn amplifi er power switch off.
CAUTION
Make sure antenna is always low-
ered completely in the travel posi-
tion. Leaving the antenna in a par-
tially raised position during travel
can damage the gear mechanism.
Always align the directional handle
to down before lowering the an-
13.7 SIGNAL AMPLIFIER
Refer to your TV Antenna Manual.
13.8 DASH TELEVISION
120V (ONLY)
Refer to manufacturer's manual for operating in-
structions and maintenance information.
The dash TV requires 120-volt AC power. Power
is provided by 120 volt shore or generator power.
The optional bedroom TV (120v AC or 12v DC) al-
lows you to view the television without the genera-
tor running or shore power available. Please note
that it is necessary to have adequate 12-volt power
in order for the TV to operate.
Fig. 13-8 TELEVISION
Bedroom (Optional)
NOTE
The Dash TV is connected to an
automotive relay system, which discon-
nects the power to the TV when the
vehicle is running.