Triple E COMMANDER - Care and Cleaning; Child Restraints; Mirrors

7-4
7.6.3 CARE AND CLEANING
1. Be careful not to damage the hardware or the
webbing of your seat belt. Take care not to
pinch them in the seat or doors.
2. Check belts and hardware from time to time.
Replace any damaged parts. Do not modify or
remove the belt system.
3. Keep belts clean and dry. If they need clean-
ing, use a mild soap solution in warm water.
Do not use hot water, abrasives or bleach.
These may weaken the belts.
4. If you experience a severe impact, check for
and replace any damaged parts.
7.6.4 CHILD RESTRAINTS
In most jurisdictions across North America, child
restraint systems are a legal requirement. In order
to provide the best in safety measures for your
child in case of an accident, we make the following
recommendations:
1. Purchase a certifi ed child restraint system.
Make sure the system comforms to all Ca-
nadian and US standards for safety require-
ments.
2. Make sure that the system will attach to your
vehicle conveniently and provide safety for
your child every time it is used.
3. Be sure that the restraint system is suitable
and adequate for your child's age, weight
and height. Check the label for this informa-
tion.
4. Ensure that the child restraint is installed per
the instructions provided with the restraint.
If you are unsure please contact the restraint
7.7 MIRRORS
Whether your vehicle is equipped with standard
or power electric mirrors, always check the adjust-
ment on your mirrors for maximum rear visibility
before driving.
The power electric mirrors ( Commander only) may
be adjusted using the multi-directional switch locat-
ed on your front panel. Select the right or left mir-
ror to be adjusted and then press the buttons until
you experience the best visibility. When you have
adjusted both mirrors for maximum visibility, place
the selector switch in the middle, neutral position
to cut off the power to the switch. This will prevent
accidental mis-adjustment of mirror settings.
The power switch adjustment is intended for fi ne
correction in mirror settings. If you are unable to
adjust your mirrors, you may need a coarse ad-
justment. This can be done by loosening the set
screws at the ball and socket of your mirror (see
Fig. 7-5). Adjust to the proper settings and then
tighten the screws. After this, fi ne adjustment
should be possible.
Your mirrors may also be equipped with defogging
or de-icing elements. The ON-OFF switch for the
heater mirrors is located near the remote mirror
controls.
COMMANDER / EMBASSY
Fig. 7-5 MIRRORS
Set screw location