EasyManua.ls Logo

Triple E COMMANDER - Page 75

Default Icon
138 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9-4
COMMANDER / EMBASSY
Make very sure that everyone is standing clear
of the interior and exterior path of the slide-out
as you extend it, and just as important when you
WARNING
Fig. 9-5 ROOM EXTENDED
Make sure travel locks are removed be-
fore extending the slide-out.
Make sure travel locks are fastened se-
curely before moving the motorhome.
WARNING
IMPORTANT
The hydraulics that operate
the slide-out are run by a 12-
volt pump. When operating
the slide-out, make sure your
batteries are fully charged or
you are hooked up to 120 volt
power. You may also choose
to use the Generator (option-
al) on your motorhome.
3.
To Extend:
On the slide out room control panel, turn
the power lock key to “on’, press and hold
the power lock key to “on’, press and hold
the control switch located above the en-
trance door until it is fully extended. Make
trance door until it is fully extended. Make
Fig. 9-5 ROOM EXTENDED
trance door until it is fully extended. Make
Fig. 9-5 ROOM EXTENDED
sure it is fully extended so that all weather
Fig. 9-5 ROOM EXTENDED
sure it is fully extended so that all weather
Fig. 9-5 ROOM EXTENDED
seals will be in their proper alignment.
CAUTION
Never move your mo-
torhome with the slide-out
extended. Severe damage
could result. Before mov-
ing the motorhome, the
slide-out must be securely
retracted and all travel locks
4.
To Retract:
Be sure that there are no obstructions inside
or outside the motorhome that would prevent
easy operation. Turn ignition to accessory po-
sition and turn the jack control panel on. Press
and hold the control switch on the slide out
control until the room is back in place. Install
the travel locks and prepare the rest of
the motorhome for travel. Turn key switch on
the slide out control to the "off" position and
remove the key.
5.
Set-Up:
Service by a professional, adjustments, regu-
lar maintenance and replacement of weather
seals as needed will extend the life and com-
fort of your slide-out unit.
6.
Seals:
Cracked and worn weather seals may allow
moisture and dirt to enter your motorhome and
cause premature deterioration of the interior.
Check the seals carefully in fall and in spring
and have them replaced if necessary.
However, extended travel and use in severe
weather conditions may cause a more rapid
deterioration of some components, especially
weather seals. In some extreme circumstanc-
es it could happen that these would need to be
replaced outside the terms of your warranty.

Table of Contents

Related product manuals