Y-Axis work for roller: The laser head stops at a fixed position, the feeding
axis moves one【Feed Distance】, and the laser head cuts once. If enable
【Y-Axis Work For Roller】function, 【Feed Switch】,【U-Axis For Feeding】
functions shall be enabled and parameters such as【Feed Distance】,
【Feeding Mode】,【Feeding Delay Mode】shall be set as required. Please
refer to the Chapter 3.5 for more details about the calculation of distance
per pulse of U axis.
In order to avoid deformation or position change of cutting material
caused by u-axis feeding, the material can be fixed by blowing and
pressure through Y-axis, and the【Y&U Axis For Feeding】function needs
to be enabled. Other usage scenarios can be adjusted by users as required.
To Next Page
Loading...