Trocen AWC708C Plus - 7.6 MultiHead Settings

AWC708C PLUS Motion Control User Manual
WWW.SZTROCEN.COM
96
Table7-5-1 Auto Reset Settings Instruction
Name
Instruction
X HardLimit
HardLimit switch of X axis. If use HardLimit, enable the function here.
Y HardLimit
HardLimit switch of Y axis. If use HardLimit, enable the function here.
Z HardLimit
HardLimit switch of Z axis. If use HardLimit, enable the function here.
U HardLimit
HardLimit switch of U axis. If use HardLimit, enable the function
here.
V HardLimit
HardLimit switch of V axis. If use HardLimit, enable the function here.
W HardLimit
HardLimit switch of W axis. If use HardLimit, enable the function
here.
7.6 MultiHead Settings
On the Manufacture Params Settings page, move cursor to【MultiHead
Settings】and press【Enter】. Press【↑】【↓】to move cursor, press【←】
【→】to modify options, press【Z↑】【Z↓】to modify parameters and
press【Enter】to save settings.