Trocen AWC708C Plus - 7.5 HardLimit Settings

AWC708C PLUS Motion Control User Manual
WWW.SZTROCEN.COM
94
In general, we suggest users to enable axis AutoReset function, and
disable the feed axis AutoReset.
Figure7-4-1 Auto Reset Setting Interface
Table7-4-1 Auto Reset Settings Instruction
Name
Instruction
XY Auto Reset
If enable this function, when power on or reset the machine,
the XY axis will reset to origin point.
Z Auto Reset
If enable this function, when power on or reset the machine,
the Z axis will reset to origin point.
U Auto Reset
If enable this function, when power on or reset the machine,
the U axis will reset to origin point.
V Auto Reset
If enable this function, when power on or reset the machine,
the V axis will reset to origin point.