True Ice Series User Manual

TRUE ICE SERVICE MANUAL
TEC_TM_198 | REV. A | EN 03/26/2024 Page 15 of 96
truemfg.com
Ice Machine Specifications (cont.)
Plumbing Connection Requirements
WARNING!
Only connect your ice machine to a potable water supply.
USER ACTION!
DO NOT connect the ice machine to a hot water supply.
Insulate the water line from sources of heat for greater operating efficiency.
Supply water temperatures higher than the recommended maximum will cause reduced capacities.
Inlet air gap included; no back-flow device required for the potable water inlet.
This UL listed model has greater than a 1" (25.4 mm) anti-back flow air gap between the water inlet tube end and the highest
possible sump water level.
For further information, please see ul.com/database.
Water filters recommended!
TRUE recommends water filters for all ice machines. Water filters help remove particulate that reduces operating efficiency
and equipment life. Regularly changing water filters is essential for optimum-quality ice, reduced maintenance, and prolonged
equipment operation.
NOTICE!
Warranty does not cover issues caused by improper installation, lack of basic preventative maintenance, or harm caused to the
ice machine by improper use of cleaners/sanitizers or by use of reverse osmosis water that does not have a neutral pH.
Plumbing connections
Water Supply 1/2" Female NPT Fitting
Drain Connection 3/4" Female NPT Fitting
Temperature and pressure
Minimum Maximum
Air Temperature 35˚F (1.7˚C) 110˚F (43. 3˚C)
Water Temperature 35˚F (1.7˚C) 110˚F (43. 3˚C)
Water Pressure 20 psig (138 kPa) 100 psig (689 kPa)
Plumbing Connection Requirements
Min./Max. Temperature & Pressures

True Ice Series Specifications

General

Brand	True
Model	Ice Series
Category	Commercial Food Equipment
Language	English