TRUE ICE SERVICE MANUAL truemfg.com
TEC_TM_198 | REV. A | EN
P#857284
03/26/2024 Page 62 of 96
After Cleanup...
1. Promptly place all lamp debris and cleanup materials outdoors in a trash container or protected area until materials can be disposed of.
Avoid leaving any lamp fragments or cleanup materials indoors.
NOTICE ›
Some localities require fluorescent lamps (broken or unbroken) be taken to a local recycling center. Check with your local
government about disposal requirements in your area. If there is no such requirement, you can dispose of the materials with your
household trash.
2. If practical, continue to air out the room where the lamp was broken and leave the heating/air-conditioning system shut off for
several hours.
Maintenance & Cleaning
General Surface Cleaning
Door Gasket
• Clean gaskets with warm soapy water.
• DO NOT use sharp tools or knives to scrape a gasket.
• Avoid full-strength cleaning products.
Exterior
• For plastic or powder-coated parts, use warm soapy water to clean DO NOT use stainless steel cleaners or similar solvents.
• DO NOT clean stainless steel with steel wool or abrasive products. DO NOT use detergents or degreasers with chlorides or
phosphates.
During Cleanup...
1. Thoroughly collect broken glass and visible powder.
WARNING!
Do not vacuum broken glass fragments!
Vacuuming is not recommended unless broken glass remains after all other cleanup steps have been taken. Vacuuming
could spread mercury-containing powder or mercury vapor.
2. Place cleanup materials in a sealed container.
To Next Page
Loading...
Need help?
General
