7. Select the "Wi-Fi" tab to setup the wireless module.
For WPA-Personal
a. Select the "Wi-Fi" tab.
b. Fill-in the SSID.
c. Select the Encryption option to WPA-Personal.
d. Fill-in the Key.
e. Select DHCP to "ON". (For "OFF" option, please fill-in the IP Address, Subnet Mask and
Gateway)
f. After setting, click the "Set" button.
Note:
* Before setting, the entered field will be shown in yellow for reminding.
* On DHCP, user can change the printer name by another model name in “Printer Name” field.
* User also can change the raw port in “Raw Port” field.
For WPA-Enterprise
a. Select the "Wi-Fi" tab.
b. Fill-in the SSID.
c. Select the Encryption option to WPA2-Enterprise.
d. Select DHCP to "ON". (For "OFF" option, please fill-in the IP Address, Subnet Mask and
Gateway)
e. Select the EAP type option. (For "EAP-TLS" option, please upload the CA and Key for
mutual authentication, integrity-protected cipher suite negotiation, and key exchange
between two endpoints.)
f. After setting, click the "Set" button.
To Next Page
Loading...
