Note:
IP address should be shown within about 5~15 seconds after printer turn on. If not, please
refer to steps below to initialize the printer Wi-Fi module settings then to setup it again.
10. Remove the Type C cable between the computer and the printer.
11. Go to [Printers Add Printer] to add this printer via Network.
12. Select this printer and enter the setting page by double clicking on the printer.
13. Click the "Print Test Page" button to print the test page via Wi-Fi interface.
3.8.4 Initialize the printer Wi-Fi module (Option)
1. Start the TSC Console by double clicking on the icon.
2. Select the printer in the list then click the “Printer Function” button to enter the setting page.
(Refer to ch.3.53 to add the printer for first using TSC Console.)
3. Go to [Functions Wi-Fi Default] to initialize the printer Wi-Fi module settings to factory
default.
To Next Page
Loading...
Need help?
General
