TSC TTP-244 Pro Series - Setup Procedures; Setting up the Printer

- 14 -
3. Setup
3.1 Setting up the Printer
1. Place the printer on a flat,
secure surface.
2. Make sure the POWER switch
is off.
3. Connect the printer to the
computer mainframe with the
RS-232C or USB cable.
4. Plug the power cord into the
power jacket at the rear of the
printer, and then plug the
power cord into a properly
grounded receptacle.
Note:
Please switch OFF printer power switch prior to plug in the power cord to printer power
jack.