INFO MODE
15
Making a Copy of the Oven Menu
From screen 2 of the INFO MODE (Figure 16, page 13),
press the R1 soft key to access the Load Menu screen.
NOTE: This feature can be turned on or off via the
“Options” screen (Figure 19, page 14).
To save a copy of the oven menu to a smart card,
1. Insert the smart card (Figure 21).
2. Press the L2 soft key “Save to Card.”
3. Verify the oven beeps and reads “FINISHED.”
To save a copy of the oven menu to a USB drive,
1. Insert the USB drive (Figure 21).
2. Press the L5 soft key “Save to USB.”
3. Verify the oven beeps and reads “FINISHED.”
Updating the Oven Menu
From screen 2 of the INFO MODE (Figure 16, page 13),
press the R1 soft key to access the Load Menu screen.
NOTE: This feature can be turned on or off via the
“Options” screen (Figure 19, page 14).
To load a menu to the oven via smart card,
1. Insert the smart card (Figure 21).
2. Press the L1 soft key “Load from Card.”
3. Verify the oven beeps and reads “FINISHED.”
To load a menu via USB drive,
1. Verify the menu on the USB drive is named
MENU.BIN.
2. Verify the menu on the USB drive is in a folder
named TC_MENUS. This folder must not be a
sub-folder of any other folder.
3. Insert the USB drive (Figure 21).
4. Press the L4 soft key “Load from USB.”
5. Verify the oven beeps and reads “FINISHED.”
Updating the Oven Firmware
Updating the oven firmware whenever TurboChef
releases a new version will help ensure the oven main-
tains the best possible functionality. Updates can be
obtained from www.turbochef.com (link at bottom of
screen), and loaded to smart cards via ChefComm.
Physical copies can also be ordered and shipped.
Contact TurboChef for more details.
From the Oven Off screen,
1. Insert the smart card (see Figure 21).
2. While the oven is either cooling down or off,
press and hold the Info key until the oven resets
(approximately 5 seconds).
3. When the oven beeps one long high tone, the
load was successful. Remove the card and if a
second card was provided, insert it.
4. When the oven beeps one long high tone, remove
the second card to begin the reboot process.
5. When the oven restarts and the display turns on,
the update is complete. Remove the smart card.
6. Verify the oven type is set to “i3” (Figure 19).
NOTE: If the update is unsuccessful, the display will
remain off and the oven will beep one long, low tone.
If this occurs, repeat the above procedure. If the
update fails multiple times, contact TurboChef.
CAUTION: The oven will be inoperable if the
firmware update is unsuccessful!
Resetting the Oven
Resetting the oven is one way to potentially clear an
error message, should one occur. When the oven is
cooling down or off, press and hold the INFO key for
5 seconds.
Figure 21: Inserting Smart Card/USB Device
Smart Card
USB Port
Smart Card Reader Slot
To Next Page
Loading...
Need help?
General
