18 TEST MODE
Volt On
This setting should not be changed in the field unless
instructed by TurboChef. Press the R2 soft key (Figure
23, page 17) to enable/disable the voltage from
displaying in
INFO MODE
. Typically, this setting is
disabled for ovens installed outside the United States.
Erase/Default Oven Settings
CAUTION: Settings cannot be retrieved once
an erase option is confirmed.
Press the R3 soft key (Figure 23, page 17) to access
the Erase screen. From the Erase screen (Figure 26),
- Press the L2 soft key to erase counters and
fault logs.
- Press the R2 soft key to erase counters, fault
logs, menu settings, temperature settings, serial
number, date, and time. Doing so will also
default all oven options (page 14 for more
detail) to OFF, with the exception of “Load
Menu.”
To Next Page
Loading...
