SAFETY INSTRUCTIONS
iii
RF Interference Considerations
The i1 (models Soˇta, Soˇta Single Magnetron, Panini, Waterless Steamer, and NGO) oven generates radio
frequency signals. This device has been tested and was determined to be in compliance with applicable portions
of FCC part 18 requirements and to the protection requirements of Council Directive 89/336/EEC on the
approximation of the laws of the Member States relating to electromagnetic compatibility at the time of manu-
facture. However, some equipment with sensitivity to signals below these limits may experience interference.
If your equipment experiences interference:
a
Increase the physical separation between this oven and the sensitive equipment.
a
If the sensitive device can be grounded, do so following accepted grounding practices.
a
If battery-powered microphones are being affected, ensure that the batteries are fully charged.
a
Keep sensitive equipment on separate electrical circuits if possible.
a
Route intercom wires, microphone wires, speaker cables, etc. away from the oven.
Protective Earth (Ground) Symbol
This symbol identifies the terminal which is intended for connecting an external conductor for
protection against electric shock in case of a fault, or the terminal of a protective earth (ground)
electrode.
EQUIPOTENTIAL BONDING SYMBOL
This symbol identifies the terminals which, when connected together, bring the various parts of an
equipment or of a system to the same potential, not necesarily being the earth (ground) potential,
e.g. for local bonding.
To Next Page
Loading...
