TurboChef Sota

62 TROUBLESHOOTING
NO
YES
Replace the I/O Control
Board (SAGE).
Correct wiring.
NO
YES
YES
YES
NO
Is the high-limit
thermostat tripped?
Are both blower motors moving air?
Check in Test Mode - see page 14, 29
for Touch.
YES
Reset (Figure 38, page
52) and determine
why it tripped – excess
grease buildup, etc.
NO
See page 57
to troubleshoot
F1: BLOWER
(Blower Running
Status Bad)
NO
Is the solid state relay
defective or damaged?
Are either of the heaters defective?
Check in Test Mode - see page 14,
29 for Touch.
Replace the defective
heater(s).
Verify the solid state
relay is not shorted
across output.
Replace the
solid state
relay.
Is the wiring from the solid
state relay to the control
board OK? (See page 79 for
schematic.)
If this fault frequently occurs,
- Ensure the oven is cleaned daily (see pages 5-6).
- Determine if large amounts of grease-laden food are being cooked, and if
so, recommend smaller portions per cook cycle.
Troubleshooting:
F8: HEAT LOW
Troubleshooting:
F9: CC TEMP (Cook Cavity Temperature High)