TurboChef Sota

58 TROUBLESHOOTING
Troubleshooting:
F2: LOW TMP (Cook Temperature Low)
YES
Replace the defective
heater.
Replace the solid state
relay.
NO
YES
YES
Replace the I/O
control board (SAGE).
Correct wiring.
YES
NO
Reset (Figure 38, page
52) and determine why
it tripped – excess grease
buildup, etc.
Is either of the heater ele-
ments defective? (heaters
should have a resistance of
14.4 Ohms)
Is the high-limit
thermostat tripped?
Is the solid state relay
defective?
Is wiring from the
solid state relay to the
I/O control board OK?
(See page 79 for
schematic.)
Is the RTD functioning
properly?
(see Figure 39, page 53)
Ensure wiring is
correct. If necessary,
replace RTD.
NO
NO
YES
NO