Page 29 of 58 Pages
5. UP key
This key enables increasing the value displayed above the cursor, at
the clock programming and for setting of certain parameters by the
technician.
6. DN key
This key enables decreasing the value displayed above the cursor, at
the clock programming and for setting of certain parameters by the
technician.
7. START LED indicator
When the “START” LED indicator is on it; indicates that the system
is running a program.
8. FAIL LED indicator
When the “FAIL” LED indicator is on; it indicates that the cycle has
failed
either as a result of exceeding the allowable limits or the STOP
key has been pressed.
9. WATER LED indicator
When the “WATER” LED indicator is on; it indicates that there is no
water in the chamber.
10. DOOR LED indicator
If the “Start” key is pressed and the door is unlocked the light will
signal
twice and the buzzer will sound four times.
If a cycle is in progress and fails on door unlocked “FAIL” LED
indicator
will lit and a message “Door Unlock” will be displayed.
To Next Page
Loading...
