Setting the LCD Message Display
iSTAR Ultra Installation and Configuration Guide 10–3
8 Hardware Test (Onboard Ethernet 1 and 2, USB ports).
NOTES:
Ethernet tests require a good IP (Static or DHCP, and a good network link) and at least
one ICU running on the same subnet.
USB port tests require the thumb drive to be formatted to a FAT32 file format.
9 Not used.
A Erase DB files from flash. (Press SW2 GCM Hard reset, wait for LCD instructions, set rotary
switch back to 0 or F, press reset again.) This is similar to position D, but leaves the basic
Comm setup of IP, etc.
B MFG - ATE (Automated Test Equipment) (Software House only).
C Disable watchdog (Software House only).
D Restore Factory Default. Erase data base files and communication parameters from flash.
(Press SW7 Hard GCM reset, wait for LCD instructions, set rotary switch back to 0 or F, press
reset again.)
E Boot to backup image (Activate on Software House instruction only).
F ICU Block On (Read only) - Display General Messages.
Table 10-1: iSTAR Ultra Rotary Switch Functions, continued
Position Description
To Next Page
Loading...
