107
Keep the seatbelt straps and buckles clean. If they become
dirty, clean them with an alkali-free soap solution.
Protect the straps from touching sharp edges.
Protection from direct sunlight is recommended.
In order to clean the straps from dust, blow with compressed
air not less than once per year.
It is forbidden to:
– twist the straps, fold them lengthwise and allow excessive
slack;
– iron the straps;
– strap in a child sitting on the lap of a passenger;
– make changes in the belt design.
ATTENTION! When the motor vehicle moves, the seat back-
rest angle should be minimal, but sufcient for the convenience of
the driver and passengers. The seatbelts are more effective when
the driver and passengers sit up straight, resting on the backrest.
If the seat backrest is inclined too much, the seatbelt may slip,
increasing the risk of getting injured in an accident.
ATTENTION! Control the condition of plastic restriction clip
6 (Fig. 3.34) of the center seatbelt.
Unfastened seatbelt signal device.
If the seatbelt of the driver is not fastened when the ignition is
turned on, the seatbelt signal device
on the instrument cluster
turns on. The signal device turns off when the ignition is turned
off or the strap is inserted to the retractable seatbelt.
If the motor vehicle moves for more than 60 s or 500 meters
or reaches speed of 25 km/h and the seatbelt of the driver is not
fastened, an additional horn turns on.
When the motor vehicle moves and the seatbelt of the driver
is not fastened within 30 s, the warning horn turns off.
After the motor vehicle stops and then starts again, the audio
alarm algorithm will repeat, if the driver’s seatbelt is not fastened.
To Next Page
Loading...
