62
Operation of exterior mirror adjustment electric drive
Left and right exterior mirror electric drive is controlled by
single switch 9 (Fig. 3.14), located in the DSDM. Selecting the
mirror to be adjusted according to the commands from the switch
is made by one of the switches 7 or 8 of the DSDM — mirror
selection buttons. Simultaneous left and right mirror adjustment
is not possible.
Indication of readiness to adjust of the selected mirror is yellow
illumination of the respective selection button. Mirror adjustment
is disabled automatically (the mirror selection button yellow illu-
mination goes out), if switch 9 is not pressed for over 10 seconds
and the mirror selection switches have not been pressed.
Exterior mirror position adjustment is possible only with the
ignition started up or 30 seconds after shutting ignition if no side
doors motor vehicle were opened.
Mirror control is not possible when armed mode is switched ON.
System operation in armed mode
When armed mode is switched ON the system monitors the
states of the following security zones:
– side doors;
– cowl;
– T/gate;
– ignition starter switch;
– driver side door lock;
– accumulator battery voltage.
If any of the following actions take place in the armed mode:
– opening of any side door;
– cowl opening;
– T/gate opening;
– ignition start up;
– driver side door unlocking;
– accumulator battery connection after its disconnection,
the alarm system switches ON as T/signals light alarm and an
audible standard motor vehicle horn alarm for about 30 s.
To Next Page
Loading...
