73
5 key “RES” — resumption of the selected function;
6 key “CAN” — cancellation of the selected function.
Principle of operation of “Cruise control” function
1. Turning on/off.
CC function is turned on by pressing key 1 (Fig. 3.18). Repeated
press of key 1 will cancel CC function.
Pressing key 1 when CC function is activated, will deactivate
and turn off CC function. The preset speed value will be deleted
from the ECU memory.
Pressing key 2 (Fig. 3.18) when AC function is on, will deac-
tivate CC function and will activate OSL function.
Pressing key 2 when CC function is activated, will deactivate
and turn off CC function and turn on OSL function. The preset
speed value will be deleted from the ECU memory.
2. Activation.
For activation turn CC function on (indicator
lights up
white), push the accelerator pedal and reach the desired speed.
Then x the target speed by pressing key “Set +” or “Set -”, i.e.,
the system is activated (indicator
lights up green) under the
following conditions:
– the motor vehicle speed should exceed or be equal to 40 km/h
and should be less or equal to 150 km/h;
– crankshaft rotation frequency should exceed or be equal to
850 rpm or should be less or equal to 5,000 rpm;
– gearbox transmission must not be lower than third;
– brake pedal should be pushed once after starting the engine.
The accelerator pedal should be released after that. The motor
vehicle will maintain the selected speed automatically.
3. Change of the target speed.
The target speed is changed when the motor vehicle is moving
with activated CC function.
Single press of key “Set +” leads to stepwise change of the
target speed by 1 km/h.
To Next Page
Loading...
