75
– if the accelerator pedal is continuously depressed (for more
than 120 s)
– in the overtaking mode (item 4);
– if deactivation key “CAN” is pressed;
– if gear is shifted to neutral;
– the function cannot keep the preset speed (for instance, on
inclines and descents).
If CC function is deactivated (for instance, if the brake pedal
is depressed) during acceleration phase (long pressing of “Set +”
key) or deceleration (long pressing of “Set -” key), the target speed
will be changed to the current value of the speed at the moment
when the CC function is deactivated.
If the function is deactivated by pressing keys “CAN’ or “CC”,
the torque will be smoothly decreased.
7. Resumption.
Resumption of CC function is possible if key “RES” is pressed.
The target speed value will be taken from the system memory at
the moment of the previous deactivation of the function.
Resumption mode is possible only if the ECU memory keeps
the target speed value different from zero.
The pressing of keys “Set +” or “Set -” during active resump-
tion mode will lead to setting of the current speed as the target.
The resumption mode can be interrupted by pressing and holding
of keys “Set +” or “Set -” with further transfer to acceleration or
deceleration modes accordingly. The target speed will be changed
to the value at the moment when the acceleration or deceleration
mode starts.
Principle of operation of
“Overspeed limiter” (OSL) function
1. Turning on/off.
OSL function is turned on by pressing key 2 (Fig. 3.18). The
repeated pressing of the key 2 will turn off the OSL function.
To Next Page
Loading...
