Uniden BCD436HP Owner's Manual

11
VEHICLE INSTALLATION
You can mount your scanner in your vehicle, using either the supplied bracket or the optional
DIN-E sleeve.
If the scanner loses power (as when you turn off your car’s ignition with the scanners power switch
on), it can corrupt the microSD card. To ensure that does not happen, turn off the scanner before
turning the car’s ignition off.
WARNING! AVOID AIRBAG DEPLOYMENT ZONES.
Ignoring this installation concern may result in bodily harm and the inability of the
airbag to perform properly.
Mounting Using the Bracket
With the bracket removed from the radio, use the holes in the bracket as a template to initially
mark the location you plan to use in your vehicle. Be absolutely certain of what might be behind
the mounting surface before making any holes, be it above, or below, or in front of your dash,
armrest console, or other location. If you drill carelessly, expensive damage can result. If in doubt,
consult your vehicle dealer’s service department or a qualied professional installer.

Uniden BCD436HP Specifications

General

Model	BCD436HP
Antenna	Removable SMA Antenna
Close Call RF Capture	Yes
Dynamic Memory	Yes
PC Programmable	Yes
Water Resistance	No
Category	Scanner Radio
Display	Dot-matrix LCD
Power Source	3x AA batteries or USB power
Weight	10.1 oz
Type	Handheld
GPS	Optional GPS receiver supported
Audio Output	Earphone jack (3.5 mm)
Trunking Systems Supported	Motorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation Types	AM, FM, NFM, P25
Battery Life	Varies with usage
Display Type	LCD
USB Port	Yes
SD Card Slot	Yes
Frequency Range	25-512 MHz, 758-960 MHz, 1240-1300 MHz