Uniden BCD436HP Owner's Manual

78
Attenuation
Press Func then 4(ATT).
Modulation
Press Func then Channel(MOD).
Intermediate Frequency Exchange
Press Func then 7(IFX) to toggle on or off.
Start/Stop Recording
Press Func then Replay.
Note: Resets to Off when you turn off the scanner.
Store Found Tones
Press E/yes at Save Found Tones?.
Tone-Out Menu
Press Func then Menu.
APPENDIX
TROUBLESHOOTING
Scan Mode, Nothing to Scan
1. Make sure you Set Your Location to scan the Database.
2. Make sure Favorites Lists are enabled in Set Scan Selection.
3. Make sure Service Types are enabled for the Channels you want to hear.
4. Make sure you have locations programed if Use Location Control is On.
5. Make sure longitude and latitude are N and W (for N America).
6. Make sure Systems/Departments/Channels are not Avoided.
7. Make sure Favorites List/System quick key is enabled.
8. (Search with Scan) Make sure Search with Scan is enabled in Select Lists to Monitor and
the Search for Menu and for the Custom Search.
Scanning Interrupted
1. Turn off Priority Scan. Change Priority Interval.
2. Turn off Close Call Priority.
3. Turn off Weather Priority.
4. Set Channel Delay longer.
5. Set positive Channel Delay.
All Channels Out of Range
1. Increase your range.
2. Turn Location Control off for the Favorites List..

Uniden BCD436HP Specifications

General

Model	BCD436HP
Antenna	Removable SMA Antenna
Close Call RF Capture	Yes
Dynamic Memory	Yes
PC Programmable	Yes
Water Resistance	No
Category	Scanner Radio
Display	Dot-matrix LCD
Power Source	3x AA batteries or USB power
Weight	10.1 oz
Type	Handheld
GPS	Optional GPS receiver supported
Audio Output	Earphone jack (3.5 mm)
Trunking Systems Supported	Motorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation Types	AM, FM, NFM, P25
Battery Life	Varies with usage
Display Type	LCD
USB Port	Yes
SD Card Slot	Yes
Frequency Range	25-512 MHz, 758-960 MHz, 1240-1300 MHz